Melt Blown Filter Cartridges

Categories: Cartridges, Melt Blown FiltersTags: Cosmetics & Personal Care, Environmental Remediation, Food & Beverage, Industrial, Water Purification

Description

Downloads

MicroSentry™ Melt Blown Filter Cartridges

These MB Series Melt Blown Filter Cartridges are constructed of 100% polypropylene, these industrial filter cartridges do not use any additives or surfactants that will cause foaming or other undesirable effects to the filtrate. The thermally bonded microfibers create a stable, self-supporting media that meet FDA Title 21 Code of Regulations. The fixed pore construction allows for higher dirt holding capacity without unloading.

Features

Constructed of 100% polypropylene, these industrial filter cartridges use no additives or surfactants that will cause foaming or other undesirable effects to the filtrate
Thermally bonded microfibers create a stable, self-supporting media
Construction materials meet FDA Title 21 Code of Federal Regulations
Graded density construction provides true depth style filtration
Fixed pore construction allows higher dirt holding capacity without unloading
Available in standard 2 ½” and 4 ½” (BB Style) diameter configurations
End cap configurations available to fit your specific requirements

Product Specifications

Filter Type: Depth
Filter Rating: Nominal
Micron Ratings: 1, 3, 5, 10, 20, 30, 50, 75, 100 microns
Lengths: 4 7/8” to 40”
Outside Diameter: 2 1/2” to 4 ½”
Materials of Construction:
- Filter Media: Polypropylene
- End Caps: Thermally Bonded Polypropylene
Applications: RO Prefilters, Potable Water, Water & Wastewater, Plating Solutions, Food & Beverages, Chemicals, Microelectronics, Photographic Solutions

Flow vs. Pressure Drop

2.5″ OD Cartridges

25od

4.5″ OD Cartridges

45od

This chart represents the typical flow rate per 10″ cartridge length. The test fluid is water at ambient temperature. Extrapolations for multiple lengths tend to be linear, but as flows increase the differential pressure across the housing becomes more apparent.

Ordering Guide

Shelco has provided the following chart to assist in ordering process. Choose from the options below, build your part number and use it when ordering or requesting a quote.

We’ve provided the following interactive chart to assist in the ordering process. Choose from the options below, build your part number and use it when ordering or requesting a quote.

Note: Requires that your browser has Javascript enabled.

Part Number:

MB5-10

MS	5	10
Product	Micron	Length	End Cap Configuration	Gasket / O-Ring	Diameter
MB
	1 3 5 10 20 25* 30 50 75 100	5 = 4 7/8″ 10 = 9 7/8″ 20 = 20″ 30 = 30″ 40 = 40″	Blank = DOE EXP = PP Core Extender S3 = 222 w/ Fin End S4 = 222 w/ Flat End S5 = 226 w/ Fin End S6 = 226 w/ Flat End S7 = Internal O-Ring with Recessed Plug S8 = SOE w/ Spring S12 = 222 w/ Spring F = Fin End Only FL = Flat End Only	Blank = None B = Buna-N E = EPR S = Silicone V = Viton PG = Polyethylene (Santoprene)	Blank = 2.5″ BB = 4.5″ (Available only without end caps)

* 25 micron only available in BB (4.5″) diameter

Download Spec Sheet

Product Downloads

Melt Blown Filter Cartridges